ESPHome
-
Posted On MultiSensor
ESPHome MultiSensor – STL Files
All the STL you need to make the MultiSencor case with your own 3D printer. I printed this files using a Creality Ender 3 for…
-
Posted On MultiSensor
ESPHome MultiSensor – Firmware, final components choice, and wiring
End of the project, with all the details needed to do your own device Final electronic components used : Cable schematics : Minimal code (You…
-
Posted On MultiSensor
ESPHome Multisensor – Case design
To complete the project i had to design the case to include all components. For that i began using Fusion 360 for makers, but after…
-
Posted On MultiSensor
ESPHome MultiSensor – Move and presence detection
Using an LD2410C for presence and move detection. The sensor must be able to detect presence / distance and move for advanced automations. For this…
-
Posted On MultiSensor
ESPHome MultiSensor – Temperature and humidity
Using an AH10 for low cost humidity and temperature measuring As usual, paste this code in esphome gui to program your esp (If you use…
-
Posted On MultiSensor
ESPHome MultiSensor – Temperature and air pressure
This time we will use a BMP280 for temperature and air pressure. As usual, connect SDA / SCL / VCC and ground to the adequate…
-
Posted On MultiSensor
ESPHome MultiSensor – Simple LED Indicator
Now let’s configure a simple LED module to make an easy on / off light indicator. LED Module needed : Plug GND to GND, VCC…
-
Posted On MultiSensor
ESPHome MultiSensor – RGB LED Indicator
We are going to add an RGB indicator to our MultiSensor project. The module i used is a HW-479 also know as KY-016 . Parts…
-
Posted On MultiSensor
ESPHome MultiSensor – Illuminance
Make your own Home Assistant ultimate MultiSensor. First we will study illuminance sensor using ESPHome.. For this project you will need : Wiring diagram :…
-
Posted On MultiSensor
ESPHome MultiSensor – The project
I am a regular user of Home Assistant, and i need more and more sensors for my automations. So i decided to make the ultimate…
Aurélien Bordinat
I am a french computer engineer, adept of DIY, home automation and new technologies. When i’m not busy trail running, i spend some time prototyping.