D1
-
Posted On Connected PostBoxSmart PostBox
To avoid opening the postbox everyday after work, had the idea to connect it to my home assistant. For that we need to setup a…
-
Posted On MultiSensorESPHome MultiSensor – STL Files
All the STL you need to make the MultiSensor case with your own 3D printer. I printed this files using a Creality Ender 3 for…
-
Posted On MultiSensorESPHome MultiSensor – Firmware, final components choice, and wiring
End of the project, with all the details needed to do your own device Final electronic components used : Cable schematics : Minimal code (You…
-
Posted On MultiSensorESPHome Multisensor – Case design
To complete the project i had to design the case to include all components. For that i began using Fusion 360 for makers, but after…
-
Posted On MultiSensorESPHome MultiSensor – Move and presence detection
Using an LD2410C for presence and move detection. The sensor must be able to detect presence / distance and move for advanced automations. For this…
-
Posted On MultiSensorESPHome MultiSensor – Temperature and humidity
Using an AH10 for low cost humidity and temperature measuring As usual, paste this code in esphome gui to program your esp (If you use…
-
Posted On MultiSensorESPHome MultiSensor – Temperature and air pressure
This time we will use a BMP280 for temperature and air pressure. As usual, connect SDA / SCL / VCC and ground to the adequate…
-
Posted On MultiSensorESPHome MultiSensor – RGB LED Indicator
We are going to add an RGB indicator to our MultiSensor project. The module i used is a HW-479 also know as KY-016 . Parts…
Aurélien Bordinat
I am a french computer engineer, adept of DIY, home automation and new technologies. When i’m not busy trail running, i spend some time prototyping.
